Harley Davidson Engine Break In Procedure

1- Initial start up.

Harley davidson engine break in procedure. The proper break-in procedure is in Section 9 of these instructions. Harley Davidson motorcycles have a break in procedure for new bikes but did you know that its more than the engine that you need to break in. Your owners manual likely recommends a 600- 1000- or even a 1500-mile break-in process where.

Now is the time to let the engine totally cool down again. You need to ride 500-1000 miles before you dyno tune your fresh engine or big bore kit. Keep the heat down by not exceeding 3000 rpm and vary the speed.

Engine break-in is divided into four major phases. Harley-Davidson Techs Around A. Repeat the acceleration cycle from 30 to 50 miles per hour at least ten times.

Drive slowly and avoid fast starts at wide-open throttle until the engine has warmed up. To allow your engine to wear-in its critical parts we recommend that you observe the riding rules provided below for the first 500 miles. Break-In Riding Procedure.

Let the engine pull from 2500 - 3500 rpm at 50 throttle and coast it back down to 2500. Break-In Riding Procedure. The procedure for installing an SS engine is basically the same as.

Even if you. In fact nothing is worse for your engine that driving around an un-tuned engine especially for an extended period. He then allows the engine.